Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Tosh on May 18, 2017, 08:31:54 pm
-
I had a split charge relay fitted by GrippaTank 4 years ago to by system that I bought from them. I suspect its buggered because about a month go the battery wasn’t producing the ooomph it usually did regarding the water-flow. I figured that the battery was shot so replaced it but now this one is playing up, not enough water flow.
I just bought a volt-meter after a 60 mile trip back from London and tested the battery, it has 11.5v in it. So figuring it should have more than that after a slow crawl round the M25 and M3.
If its the split charge whats the situation with these? Are they easy to replace and which one is appropriate, I mean does it depend on what you’re running and battery size. I know, they're stupid questions, but haven’t the foggiest about split charge relays.
All help appreciated.
Thanks Matt.
-
Hi Matt
If your happy with how it's been just get new split relay from them, it's easy to change over that way I think it's just a push in fitting can't remember from memory
But at least they'll give fitting instructions
Also I would check all fuses and connections in case anything is loose just in case
-
I had a split charge relay fitted by GrippaTank 4 years ago to by system that I bought from them. I suspect its buggered because about a month go the battery wasn’t producing the ooomph it usually did regarding the water-flow. I figured that the battery was shot so replaced it but now this one is playing up, not enough water flow.
I just bought a volt-meter after a 60 mile trip back from London and tested the battery, it has 11.5v in it. So figuring it should have more than that after a slow crawl round the M25 and M3.
If its the split charge whats the situation with these? Are they easy to replace and which one is appropriate, I mean does it depend on what you’re running and battery size. I know, they're stupid questions, but haven’t the foggiest about split charge relays.
All help appreciated.
Thanks Matt.
Have you checked your pre pump filters? Low battery doesn't in my experience reduce flow. I'd be checking for an obstruction. A knackered Rectus fitting can cause reduced flow.
Agree re batter charge after that trip though. Should be full.
-
I had a split charge relay fitted by GrippaTank 4 years ago to by system that I bought from them. I suspect its buggered because about a month go the battery wasn’t producing the ooomph it usually did regarding the water-flow. I figured that the battery was shot so replaced it but now this one is playing up, not enough water flow.
I just bought a volt-meter after a 60 mile trip back from London and tested the battery, it has 11.5v in it. So figuring it should have more than that after a slow crawl round the M25 and M3.
If its the split charge whats the situation with these? Are they easy to replace and which one is appropriate, I mean does it depend on what you’re running and battery size. I know, they're stupid questions, but haven’t the foggiest about split charge relays.
All help appreciated.
Thanks Matt.
Have you checked your pre pump filters? Low battery doesn't in my experience reduce flow. I'd be checking for an obstruction. A knackered Rectus fitting can cause reduced flow.
Agree re batter charge after that trip though. Should be full.
Both pumps are playing up, so its not a blockage. Theres no pressure, its definitely electrical. Now Ive charged it up its working as it should, just Im charging it with an external charger, which is okay, but on some jobs you need to have the facility of a split charger.
-
Hi Matt
If your happy with how it's been just get new split relay from them, it's easy to change over that way I think it's just a push in fitting can't remember from memory
But at least they'll give fitting instructions
Also I would check all fuses and connections in case anything is loose just in case
Im a dipstick, I need to talk to Grippa, they can supply me what I need. Thanks Tony ;)
-
11.5v is flat.
With the engine running a multimeter across the leisure battery should tell you if the battery is charging or not. If its charging then the voltage reading would be around 13.9v or above.
As has been stated, first check are fuses. There should be 2, one at the starter battery and the other at the leisure battery. The relay should also have an earth so it would be an idea to check that as well.
Grippa have sold these since day one so it should be just an easy swap over if its the relay that has gone.
https://www.grippatank.co.uk/12v-24v-intelligent-split-charge-relay-100amp-3081
I'm using one of these variants atm
http://www.ebay.co.uk/itm/7mtr-Split-Charge-Kit-12V-140a-Durite-Intelligent-VSR-110a-Ready-Made-Leads/251527846525?_trksid=p2047675.c100005.m1851&_trkparms=aid%3D222007%26algo%3DSIM.MBE%26ao%3D2%26asc%3D44293%26meid%3Dfdd5b0cc145041fe836dde5ddf730831%26pid%3D100005%26rk%3D3%26rkt%3D6%26sd%3D201605898058
full fitting instructions were included.
We've also used these and found them very reliable
http://www.brocott.co.uk/smartcom-voltage-sensing-self-switching-split-charge-relay-12v-30amp/
.
-
Thankyou Spruce. I never thought of the fuse either lol.
Im going tensile in my old age here.
-
I had a split charge relay fitted by GrippaTank 4 years ago to by system that I bought from them. I suspect its buggered because about a month go the battery wasn’t producing the ooomph it usually did regarding the water-flow. I figured that the battery was shot so replaced it but now this one is playing up, not enough water flow.
I just bought a volt-meter after a 60 mile trip back from London and tested the battery, it has 11.5v in it. So figuring it should have more than that after a slow crawl round the M25 and M3.
If its the split charge whats the situation with these? Are they easy to replace and which one is appropriate, I mean does it depend on what you’re running and battery size. I know, they're stupid questions, but haven’t the foggiest about split charge relays.
All help appreciated.
Thanks Matt.
Have you checked your pre pump filters? Low battery doesn't in my experience reduce flow. I'd be checking for an obstruction. A knackered Rectus fitting can cause reduced flow.
Agree re batter charge after that trip though. Should be full.
Low battery has always reduced flow in my experience.
-
Thankyou Spruce. I never thought of the fuse either lol.
Im going tensile in my old age here.
;D
-
I had a split charge relay fitted by GrippaTank 4 years ago to by system that I bought from them. I suspect its buggered because about a month go the battery wasn’t producing the ooomph it usually did regarding the water-flow. I figured that the battery was shot so replaced it but now this one is playing up, not enough water flow.
I just bought a volt-meter after a 60 mile trip back from London and tested the battery, it has 11.5v in it. So figuring it should have more than that after a slow crawl round the M25 and M3.
If its the split charge whats the situation with these? Are they easy to replace and which one is appropriate, I mean does it depend on what you’re running and battery size. I know, they're stupid questions, but haven’t the foggiest about split charge relays.
All help appreciated.
Thanks Matt.
Have you checked your pre pump filters? Low battery doesn't in my experience reduce flow. I'd be checking for an obstruction. A knackered Rectus fitting can cause reduced flow.
Agree re batter charge after that trip though. Should be full.
Low battery has always reduced flow in my experience.
That's interesting because the first sign I get is flow stopping and BATT flasing on the controller.
-
I spoke to Oliver at Grippatank today, he's a nice guy. We deduced it was the 80A strip fuse. Probably blew when I changed the battery a few weeks back.
Anyway I've got some new strip fuses.
-
I spoke to Oliver at Grippatank today, he's a nice guy. We deduced it was the 80A strip fuse. Probably blew when I changed the battery a few weeks back.
Anyway I've got some new strip fuses.
Did you get the polarity wrong?
-
Ummm, nope. ;D
I ain't saying. But we had a laugh on the phone about it.