Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: buzzing on May 11, 2017, 08:21:27 am
-
Going to get rid of my floor ply and should I paint the floor before deciding on fibre glassing?
On another note, want to get van fitted out- more anchor points and a tank with autostop and RO fitted system. Any suggestions on who to get to fit these?
-
try it yourself it is quiet easy https://www.youtube.com/watch?v=hFc1cxIF2xA
-
If there's any bare metal showing then it would be a good idea to paint over it to stop rust, don't waste your time and money on
fibreglass as there's no need.
-
Do you think just rip out floor ply and paint anyway, then worry about the fibre glassing later? Where you buy that paint?
-
I have never seen the point of doing any of it ???
If the system is put together as it should be , then why make the van heavier than it needs to be .
But then i am a stickler for leaks and mess , all i ever use is plastic load liners .
-
Is it easy to take out when you want to sell the van or remove it?
-
If you are asking me that question then yes load liners are not fitted as such , they just sit on the floor so can be taken out at any time , they are vehicle specific , they may not even do one for your van .
Mine is actually from a Mazda estate car and it fits bang on between my inner arches of the Fiat fiorino , and the best bit was i found it propped against a wheelie bin , one mans rubbish is another mans treasure ;D ;D
The fibreglass is pretty much going to be there for good once cured off .
Rich
-
This is the load liner , it takes about 15 minutes to strip the van bare if i need to .