Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: Tony Stewart on April 22, 2016, 05:36:29 pm

Title: Replacement Pressure Washer Front Rubber Foot
Post by: Tony Stewart on April 22, 2016, 05:36:29 pm

Hi Guys
I have managed to tear off the rubber front foot from my Loncin Pressure washer when I ran it up the ramp into my van. It seems to be secured by a screw thread onto a nut. Can you tell me when I can replace it or buy a better fitment that won't be as flimsy. I am so clumsy...............
Thanks a lot.

Title: Re: Replacement Pressure Washer Front Rubber Foot
Post by: Smurf on April 22, 2016, 06:24:34 pm

Why not just buy a cheap rubber door mat then when setting up just put it under the front foot as will do the same job.
That's what I do anyway as I have two washers with the front rubber strips missing.

Title: Re: Replacement Pressure Washer Front Rubber Foot
Post by: chris scott on April 23, 2016, 06:27:17 am

Rutland pumps.

Title: Re: Replacement Pressure Washer Front Rubber Foot
Post by: Tony Stewart on April 23, 2016, 07:40:38 am

Chris thank you.
........I dont want to put down a rubber matt only because when I load it on to the van it will scrape the flooring which is speedlined and so will damage it.

Title: Re: Replacement Pressure Washer Front Rubber Foot
Post by: Smurf on April 23, 2016, 02:14:08 pm

That's the advantage of running around in an old banger van as it don't matter if the floor gets damaged or not I guess.