Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: W.booler on January 06, 2016, 08:27:44 pm

Title: 000 -075 ppm?
Post by: W.booler on January 06, 2016, 08:27:44 pm

Hi folks, hope you can help me.... I'm putting a few customers on wfp this week. The problem is I have filled a new wydale tank half  full through my di..  I haven't fitted a pump to the van yet, so have been filling the back pack from a tap on the tank. I'm getting a tds 000 through the di, but ive just taken a reading from the tank of 075..  Does the tank need flushing out? Do you guys pump tap water into the tank and then di in the van? I'm a bit wet behind the ears but a 075 ppm rise from the tank seems excessive to me?  I have a bit of time this weekend so could fit pump and controller and then double di in the van..is this where I have gone wrong. Thanks in advance  :)

Title: Re: 000 -075 ppm?
Post by: JSMC on January 06, 2016, 09:01:52 pm

i use my di from outside tap through two vessel's and it reads 0 the tap water around here is about 29ppm.

seems strange you are getting a reading like that. Sounds like tank may need cleaned.

Title: Re: 000 -075 ppm?
Post by: Smudger on January 06, 2016, 09:04:14 pm

If it's brand new tank I usually give it a clean and flush out.

Di only is ok if your tap tds is low but can rise dramatically once thr resin is spent, if your monitoring the tds closely then it maybe safer for you to di after the tank .

We process our water into holding tanks then transfer to vans as required

Darran

Title: Re: 000 -075 ppm?
Post by: W.booler on January 06, 2016, 09:18:32 pm

Thanks guys. Yes, Darren I have a tap tds of 96 and have just tested outside di and I'm getting a 000 reading.. I'll give the tank a good flushing out tomorrow as my reading has gone up from di of 000  before going into tank and then coming out at 075!

Title: Re: 000 -075 ppm?
Post by: Clever Forum Name on January 06, 2016, 10:51:51 pm

You did make sure the di was the right way round when you filled the tank?

They have in and out ....

Title: Re: 000 -075 ppm?
Post by: rosskesava on January 07, 2016, 01:39:05 am

Take a TDS reading of what comes out the brush.

Then you'll know what know what the actual reading is of the water you are cleaning with is.

Title: Re: 000 -075 ppm?
Post by: W.booler on January 07, 2016, 07:55:51 am

Thanks guys. Hi Damien hope you're well  :)  yeah I've got the vessel the right way around. I'll check reading from brush also, and go back and reclean the few that I've done!and give tank a good clean...

Title: Re: 000 -075 ppm?
Post by: Clever Forum Name on January 07, 2016, 02:03:42 pm

Hi bud. Yeah very well indeed :)

If you get stuck gimme an email.

Title: Re: 000 -075 ppm?
Post by: W.booler on January 07, 2016, 02:13:08 pm

Will do. Thanks :-)

Title: Re: 000 -075 ppm?
Post by: johnny bravo on January 07, 2016, 06:14:07 pm

take a reading of water leaving your DI vessel before going into your tank.     id empty your water tank and start again,    try and dry your tank out, use a pole with a dry  non fibrous cloth.   then fill up again, keeping an eye on water entering the tank.
so put DI vessel before the tank.          Unless you are using your DI vessel after your tank.
if your waters so low tds,     just use an ro,    shouldnt need a di vessel.

Title: Re: 000 -075 ppm?
Post by: W.booler on January 07, 2016, 06:59:11 pm

Thanks Johnny.. It's definitely the tank. Filled backpack straight from di today and got a 000 reading.. Used mine and my mates tds meter and tank gave us both a reading of 075, so I'll drain and clean tank and start again.

Title: Re: 000 -075 ppm?
Post by: Smurf on January 08, 2016, 02:02:23 pm

I suspect it's because the tank is new and due to the manufacturing procces just needs flushing through with pure.
Should be fine after that.

Title: Re: 000 -075 ppm?
Post by: W.booler on January 08, 2016, 02:35:10 pm

Thanks Smurf  :)

Title: Re: 000 -075 ppm?
Post by: johnny bravo on January 08, 2016, 06:04:37 pm

aint it great when things dont go smoothly,       its all part of the learning curve  into wfp  cleaning,   lots of  mistakes to be made
good luck,     

Title: Re: 000 -075 ppm?
Post by: JSMC on January 08, 2016, 09:10:04 pm

Just had a quick check what comes out of hose reel and got a tds  11