Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: duncan h on September 17, 2015, 08:32:00 pm
-
Just got a new powerup hd reel :) it only takes 6mm hose.
I was reeling the hose on the reel and it must have kinked a dozen times. Does 6mm kink more or is it a bad hose.
I warmed end up in a cup of water and it went a lot softer than my 8mm hose. Is this because its thinner or crap hose
-
Depends where you brought it from,
New hose does tend to kink for the first couple of days then settles down, our 6mm hose is great
Darran
-
Again mate it depends on the place it's bought, I use the 8mm red hose from circuit hydralics, very really kinks and good quality hose
-
;)
-
How's things Darran, am en route to another one tomora 🚂💨
Did u have any luck with your local one
-
Again mate it depends on the place it's bought, I use the 8mm red hose from circuit hydralics, very really kinks and good quality hose
I got it from Circuit Hydraulics, but its 6mm not 8mm. My 8mm never kinks. Same stuff/Hi Viz. Only unrapped it and would it onto new reel, but it kinked loads of times
-
I bet your power up reel is good .
A nice luxury to have
-
I bet your power up reel is good .
A nice luxury to have
Waiting for parts to connect to water, but should save my arms.
LUXURY! a must. Cant see the point in making work harder than it is for the few hundred pound between windy reel and power reel
-
i've never had any of my minibore hose kink even using hot water running through it.
Sounds like microbore hose is a pile of poop if it does.
-
i've never had any of my minibore hose kink even using hot water running through it.
Sounds like microbore hose is a pile of poop if it does.
It should firm up with winter water in it. I was shocked how soft it went after dipping it in boiled water. *mm goes a little softer. 6mm goes limp. It does way a lot less though
-
The wall thickness of the microbore hose is obviously a lot thinner then compared to minibore hose?
-
The wall thickness of the microbore hose is obviously a lot thinner then compared to minibore hose?
Circuit hydraulics is the same wall thickness 6mm i/d 11mm o/d 8mm i/d 13mm o/d
As said ours doesn't kink ( and I've got 8 reels of the stuff on the go )
Darran