Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Robin Ray on July 27, 2015, 10:34:52 pm

Title: Water heaters
Post by: Robin Ray on July 27, 2015, 10:34:52 pm
In the US they have the propane little giant water heaters do we have anything like it in this country?

I have considered pressure washer burners however the flow rate may not be enough to trigger the burner. And most other instantaneous water heaters cant take the pressure of a carpet cleaning machine.

Any Ideas?
Title: Re: Water heaters
Post by: john martin on July 27, 2015, 11:02:21 pm
In the US they have the propane little giant water heaters do we have anything like it in this country?

I have considered pressure washer burners however the flow rate may not be enough to trigger the burner. And most other instantaneous water heaters cant take the pressure of a carpet cleaning machine.

Any Ideas?
Ha , i was looking at this yesterday , thought about ' building ' an even smaller portable version of this based on the 12 liter lavor burner ... i presume u could get some sort of flow on/off switch ? 
The premade hotboxes look bulky .
https://www.youtube.com/watch?v=HTSXlOS8sdI
dont know much about them to be honest .
You could make up shower heater connect to a gas cylinder ,  i do kinda fear carrying gas or running burners in the van though .
Title: Re: Water heaters
Post by: Mike Halliday on July 28, 2015, 07:29:21 pm
I'm using a propane burner at the moment, it's a lot cleaner burning that a diesel burner and the temp is very easy to regulate  a bit like a gas hob, you can turn the gas down to an almost flicker, the diesel Burner is on full constantly no adjustment which makes it very hard to control.

But although the Burner  is less bulky than a diesel hot box you have a gas bottle to fit as well. Propane is cleaner so you can fit the heater anywhere in the van but a diesel burner needs either a chimney through the roof or be next to the door..

You can use a portable propane shower like the window cleaners but it can't take the pressure but you can fit it before the pump so the pump pulls the water through the heater  or if you use it with a truckmount you could use it to fill the water box to preheat the water
Title: Re: Water heaters
Post by: Robin Ray on July 28, 2015, 09:35:59 pm
How do you use it Mike?

I was considering using it to maintain the temperature in a  small buffer tank on a thermostat  and a 12v pump to circulate the water. Then draw the water off in to the  main pump from there.
Title: Re: Water heaters
Post by: Mike Halliday on July 28, 2015, 10:23:12 pm
Pump direct  into the burner then out of the burner through a pressure release valve (which bypasses back into the fresh water tank when I release the wand trigger ) then into the solution line to the wand.

The burner is constantly heating the water, when it's not being used it bypasses back to the tank which preheated the fresh water.

My burner is Rated to 3000psi so can handle the pump pressure
Title: Re: Water heaters
Post by: Robin Ray on July 28, 2015, 10:27:25 pm
Do you have a little giant or similar?
Title: Re: Water heaters
Post by: Mike Halliday on July 28, 2015, 10:35:40 pm
This is when I bought it, I have cleaned it up and altered the plumbing.

(http://www.cleanitup.co.uk/smf/1438119325_image.jpg)

Title: Re: Water heaters
Post by: Robin Ray on July 28, 2015, 10:54:52 pm
I wish there was some thing like that on the market now.