Clean It Up
UK General Cleaning Forum => General Cleaning Forum => Topic started by: wpclean on May 20, 2015, 06:14:20 am
-
Can anyone recommend some good quality work trousers/bib n brace for pressure washing ? I am going through so many pairs, mainly due to me having short legs, and the bottoms just get torn up ! I have looked on fleabay, but can't see owt !
Thank you .
-
I have north face pants that I use occasionally but the most important is the wellys, I use steel toe capped ones for ppe. I tend to just were shorts a lot so it's just a quick change and wash ya knees down ;D
I also have orange pants from screw fix for working on railways, these are waterproof and cost about £15
-
I have been looking at these, and although the waders look a bit extreme, I might give them a try ;D
http://www.bestworkwear.co.uk/portwest-s453-sealtex-bib-brace.html
http://www.bestworkwear.co.uk/portwest-fw74-chest-wader-s5.html?___SID=U
-
Probably the first ones, unless you fancy wading through some deep water haha
-
I know the waders look like overkill, but I always end up with wet legs even with waterproofs. I suffer with the cold as well, so when I get wet I really feel it in my bones. Also I always end up with bleached workwear from using hypo, so waders being chest high would prevent a lot of this ;D
-
I use the 15 quid ones from Screwfix. They last a few months, get torn, get bleached from hypo then I buy a new pair.
-
I use the 15 quid ones from Screwfix. They last a few months, get torn, get bleached from hypo then I buy a new pair.
You my friend are living the dream ;D
-
I use the 15 quid ones from Screwfix. They last a few months, get torn, get bleached from hypo then I buy a new pair.
You my friend are living the dream ;D
;D
I use these too, tried the cheap yellow ones once, put them on took two steps and ripped the arse out of them :(
-
Waders all the way.