Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Steven Butler on May 14, 2015, 08:23:47 pm
-
What length would a standard twin vac machine be ok with....50ft???
Or 25ft
-
50 ft ok any longer and lose vac strength all depends on what vac system you have and how old machine is.
-
What is the machine?
-
Possibly an Airflex pro..standard
-
5o foot.. no more!
-
I use 50ft on the scorpion all day , most days ok its a tripple, but when I used a ninja with twin vacs in series it struggled
I can quite easily use 100ft or more with Scorpy, but its rare that I use anymore than 50ft
Stuart
-
Steve, in series 50' 1.5 inch is fine.
In parralell I have used 50' 2" with 25' 1.5" and it did the job fine. Just an extra dry pass to be sure ;)
Lew
-
Cheers fellas.
Tim IF your banned from cleantalk email me, lost your email address mate
-
The longest we have had on our spitfire 3.2 is 300 foot it was not as powerful as normal.
Most of the time we have a max of 150.
On the portable we had a few years ago had to take the machine up some stairs because we did not have enough hose but got it stuck against the wall because the stairs twisted could not go up or down.
Better to have extra hose if possible and leave it downstairs.
-
steve im on timbohandley@gmail.com
wont be seeing me on the other forum any more our kid!!!!!
-
i can use 100 foot of pipe on my jag and it great, but on my old Alltec I wouldn't use more than 50, all depends on the portable you have
-
used 100 foot on the storm with no problem, in fact it rarely leaves my van now! i definately wouldnt use more than 100foot as i dont have any more hose/sol pipe!!!!
-
50ft 2" on my standard Airflex Pro no problem at all, sometimes go to 75 if it's a huge townhouse but an extra dry pass or two works fine. BUT if your not using a heater of some sort and cold water 75ft can leave the carpets damper than I would like. Going to upgrade the vacs soon so hopefully that will improve things.
-
Thanks for all the replies.
Can 25ft of 1.5" be used with 25ft 2"? With the right connector obviously.
-
Yes , what's the motor configuration of your machine?