Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: tim handley on May 07, 2015, 03:56:31 pm
-
did a job today and my wand wouldnt stop spraying, even when trigger wasnt being pulled.... any ideas??? couldnt see anything untoward with the mechanism visually...... ???
-
Either the spring is not pushing the plunger back up ( on this photo the spring cannot be seen its inside the thread bit at the bottom which is not cuts away ) or thier is some obstruction stopping the Teflon seal ( the White washer in the middle) seating correctly....... so allowing water to escape past.
Strip it down and clean it out
(http://www.cleanitup.co.uk/smf/1431011877_image.jpg)
-
many thanks mike...