Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: scrubbitt on April 16, 2015, 07:32:57 pm

Title: Enforcer vac motor
Post by: scrubbitt on April 16, 2015, 07:32:57 pm
Has any body changed a motor
In the enforcer
If so was it easy or difficult
Thanks scrubbitt
Title: Re: Enforcer vac motor
Post by: john martin on April 16, 2015, 08:08:56 pm
Quote from: scrubbitt on April 16, 2015, 07:32:57 pm
Has any body changed a motor
In the enforcer
If so was it easy or difficult
Thanks scrubbitt

I would say easy  ,  but if you dont have the various tools lined up it might take u a bit longer the first time .
See in the pic  ,  it has three outer bolts attached to the body  ( green tips on them )  . They hold the metal plate which the 5.7 is attached to ( its actually a 5.7 adapter )  . 
So undo the outer bolt nuts and the motor will come off still attached to its adapter . You then just remove the three bolts on that to remove the motor .
I think i use about two wrenches /sockets ... and perhaps a long nose pliers to hold on or two of the nuts on the adapter plate while removing .
It becomes obvious when u do it .
Wires ... the two black wires pull off the motor and the green earth is on a little screw .
Its a very well build machine  :)

(http://i61.tinypic.com/20zsj01.jpg)
Title: Re: Enforcer vac motor
Post by: davep on April 16, 2015, 08:32:24 pm
John have you any tips on servicing as mines 6 months old now.
Title: Re: Enforcer vac motor
Post by: john martin on April 16, 2015, 08:49:24 pm
Quote from: davep on April 16, 2015, 08:32:24 pm
John have you any tips on servicing as mines 6 months old now.

I dont think so  , i would no expert on maintenance services though , i more of a fix it when it goes bad guy  .
But six months sounds like a very short time to me  for anything to need replacing unless your unlucky .
Title: Re: Enforcer vac motor
Post by: scrubbitt on April 20, 2015, 10:24:22 pm
Hi John
How easy is it to get into the enforcer
Haven't had mine long
Anything I should know before opening
And how easy is the pump to replace
Thanks steve
Title: Re: Enforcer vac motor
Post by: john martin on April 20, 2015, 10:58:30 pm
Quote from: scrubbitt on April 20, 2015, 10:24:22 pm
Hi John
How easy is it to get into the enforcer
Haven't had mine long
Anything I should know before opening
And how easy is the pump to replace
Thanks steve
It couldn't be easier to get in  ... just undo the two bolts in front and its free to open  ....  open it up and put a chair or something behind it to rest the top on .
I haven't removed the pump yet  ...  the pump is standing on its head on a rubber mounting plate for shock absorption , i sure it just four bolts holding it  , should be straight forward  .  You can see the top of the pump motor in the bottom right of the  pic  ...  metal thing with red and black hose running over it .