Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: pt on April 27, 2006, 07:46:10 pm

Title: priming for wfp changeover
Post by: pt on April 27, 2006, 07:46:10 pm

Started week one this week and have been handing out explainatery wfp leaflets ready for change over in five or six weeks.Doing diy setup, tank should arrive this week,got shurflo,varistream,di cylinder and resin all ready to outfit my van. Got my ro- man set up producing 1 tds down from 380. Just got to order my poles and looking at a tucker. Can anyone tell me if these are worth using?Cannot wait to stop using ladders.

Title: Re: priming for wfp changeover
Post by: Chris Cottrell on April 27, 2006, 08:11:21 pm

Haven't seen you around yet Paul, but good luck anyway mate
Remember Rinse Rinse Rinse :)

Chris

Title: Re: priming for wfp changeover
Post by: matt on April 27, 2006, 09:09:18 pm

i swear by the unger poles

very cheap and last ages, the only thing to wear on them are the locking cones and they cost a few quid each to replace

Title: Re: priming for wfp changeover
Post by: stuart webster on April 27, 2006, 09:45:48 pm

Get real poles not unger if doing anything over 1st floor

Title: Re: priming for wfp changeover
Post by: AuRavelling79 on April 27, 2006, 09:54:38 pm

Wot Matt and Bear said. I use Unger perfectly well, but their limit (IMHO) is really ground, first and some second floor. (OK for 3 - storey town houses but if I had loads I'd change poles)

But fine for anything you would have done off a ladder. Also with the hose up the outside you can change the brush to a short pole at the click of a release thingy!

Title: Re: priming for wfp changeover
Post by: jeff1 on April 29, 2006, 12:46:14 am

Been priming my customers for the change over in a few months, and so far there response has been nothing but possitive. 

One said she can't wait to see my pole and can she have a go on it ; :o ;D ;D