Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: david mark on February 02, 2015, 05:48:15 pm
-
Just. Purchased vyair pump 12 lpm got in wired via controller but pressure Switch keeps cutting on and off, set calibration up to 99 still not working properly if I bypass microbore it works fine put my old sureflow pump back on and averything works fine is there adjustment on the pressure switch on the vyair pump or can I bypass the pressure switch and rely on the one in the controller any help would be appreciated.
-
I have a 7lt Vyair pump and it's cal is 30 or there about's, It sounds like you got it set to high, we run two man between 60-70 on controller. It's dead ending as you have to much pressure
-
Its hooked up to the 6 mm I/d hose microbore ill try it on the 8mm minibore tomorrow hopefully that will work. What size hose are you using.
-
Micro and before that mini 8mm.
I'd try running the pump low and gradually work upwards to a point where your happy after recalibrating it.
-
Remember the 12 lit vyair pump is 120psi pump so will dead end through thin hose. No just the hose but the pole hose and jets. I use the 10 liter and have not probs as its a 100 psi pump.
-
What controller are you using?
If it's Varistream then they recommend disconnecting the pressure switch anyway.
-
Spoke to vyair they said the 12L is to powerfull he recommends the 7L. So sent it back replacement in the post.
-
You will still be impressed with a 7lt.