Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Steven Butler on February 02, 2015, 10:20:54 am

Title: Foam machine for upholstery
Post by: Steven Butler on February 02, 2015, 10:20:54 am

Has anybody used or use a cristal fusion machine for upholstery cleaning.
Would appreciate any info/review/opinions.

Title: Re: Foam machine for upholstery
Post by: tonner0 on February 02, 2015, 03:56:24 pm

Steven, I have a Cristal Fusion machine and it does the job it's designed for. You generally need a prespray for the dirtier parts, but customers are always happy with the result. It can spray the foam around a little,  but not too bad generally. You must run plain water through it after finishing, to clean the machine otherwise it can get blocked. I have seen a couple recently at reasonable prices. It also leaves a stain protection on the fabric too. Easy and quick to use.

Title: Re: Foam machine for upholstery
Post by: Radek Jablonski on February 02, 2015, 04:06:45 pm

steven did you consider  foamer, drill brush and towel off or extracted.?

Title: Re: Foam machine for upholstery
Post by: Steven Butler on February 02, 2015, 04:39:22 pm

Im looking into anything Radek cheers.

Tonner can i have an email add for you...got some questions if you get a minute please

Or email me
stevenbutler06@btinternet.com

Title: Re: Foam machine for upholstery
Post by: peter maybury on February 03, 2015, 09:37:53 pm

I used von schrader machine for many years. On dirty suites prespray is needed which increases the drying time.
I found that with a good upholstery tool I can get better result a lot quicker without increasing the drying time.
The dry foam is a neutral detergent and so just did not have the bite.
Peter