Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: supernova77 on December 04, 2014, 06:30:20 pm

Title: 1 heater, 2 pumps..?
Post by: supernova77 on December 04, 2014, 06:30:20 pm

Hi All,

1 heater, 2 pumps...

Can it work?

Can you have the heater before the pumps or not?

Thanks,
Andy  ;)

Title: Re: 1 heater, 2 pumps..?
Post by: LWC on December 04, 2014, 07:08:10 pm

I very much doubt they would pull thru the heater enough to start it up...if at all

I have 1 pump, heater, t peice to 2 reels. Works a treat

Title: Re: 1 heater, 2 pumps..?
Post by: robert mitchell on December 04, 2014, 07:16:49 pm

i wouldn't have the heater before the pump as i think the heat could damage them .

two pumps pulling through the heater should be fine as long as the flow isn't higher than the rating for the heater which is 6lpm or 8 lpm .

it will ignite as it will pulling more through than one pump would .

Title: Re: 1 heater, 2 pumps..?
Post by: NWH on December 04, 2014, 07:34:31 pm

It would work with a diesel heater you can put water through it flat out without a problem to give you enough for 2 poles although you wouldn't need to be flat out on the pump

Title: Re: 1 heater, 2 pumps..?
Post by: Deangsi on December 04, 2014, 08:31:31 pm

I have two pumps going through the heater just make sure you fit in this order
Tank
Pumps
One way valve of each pump into t piece
Then through heater
Then out heater into t piece
Then to both deals with a tap before one real to even flow on both deals

One way valves are so the pumps don't fight against each over and pump back on eachover which they do lol one way valve is esential

If you require pics please from me an email deanlawrence89@hotmail.co.uk

Title: Re: 1 heater, 2 pumps..?
Post by: slap bash on December 05, 2014, 10:27:35 am

.