Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: mark15 on November 16, 2014, 08:15:17 pm

Title: corwoods heater & hydro flo pump
Post by: mark15 on November 16, 2014, 08:15:17 pm

i currently use a hydro flo pump controller with a shurflo 100 psi pump...ive always had it set at 35... now ive fitted a heater... does anyone else use this combination & if so what is yours set at?

Title: Re: corwoods heater & hydro flo pump
Post by: slap bash on November 17, 2014, 10:38:35 am

There are to many variables to answer, but the best is to try and see. IT should work.

Title: Re: corwoods heater & hydro flo pump
Post by: Nathanael Jones on November 17, 2014, 11:46:10 am

In my experience the L5 heaters take a higher flow rate to run reliably than most UK window cleaners are used to using - - but you do tend to work a little quicker with hot water so it does balance out a bit.

Title: Re: corwoods heater & hydro flo pump
Post by: neiljoust on November 19, 2014, 04:31:25 pm

i have mine on 45 hot water all day