Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: garybristow on November 13, 2014, 08:57:15 pm

Title: Blazer gt upholstery tool
Post by: garybristow on November 13, 2014, 08:57:15 pm

Don't know if it's just me , when I use the prochem upholstery tool it fires out far too much water! I turn the solution pressure to 3.5 and alter the spray on the tool , I can't seem to get a fine spray like you would on a porty
Any ideas?
Gary

Title: Re: Blazer gt upholstery tool
Post by: Robin Ray on November 13, 2014, 11:45:35 pm

Use a porty ;D

The Sapphire tool is superb but if you want to use the prochem tool could you change the jet size? Or fit an inline valve like on the sapphire to further reduce the flow?

Title: Re: Blazer gt upholstery tool
Post by: Mike Halliday on November 14, 2014, 06:37:36 am

I have drilled a hole at each end of the vacuum slot so if the tool seals on the fabric the excess water still gets sucked up.

Title: Re: Blazer gt upholstery tool
Post by: stuart_clark on November 14, 2014, 12:52:19 pm

The Saphire hand tool is superb but the Sheerdry is better



Stuart

Title: Re: Blazer gt upholstery tool
Post by: elliott cleaning on November 14, 2014, 08:31:16 pm

What size jet are you using, Gary?   Think the standard jet of the Prochem one is 8002.  Try changing it to a 01. - also try changing the psi down to 100

Title: Re: Blazer gt upholstery tool
Post by: garybristow on November 16, 2014, 06:33:35 pm

Thanks everyone
The jet size might be the answer
Gary