Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: Jettaway on September 23, 2014, 07:47:21 pm

Title: re sanding a commercial paved area
Post by: Jettaway on September 23, 2014, 07:47:21 pm

I cleaned around 1,200m2 of paved road the other month and they have decided that they want it all re sanding. Normally on commercial I don't re sand, as we all know they don't need it and just eat through bags of sand.

Even though I tried to talk them out of it they have decided to go ahead with it.

Are there any secrets to do this or do I just need to factor in the cost of dry sand and enjoy opening all them bags :'(

Title: Re: re sanding a commercial paved area
Post by: Neil Jones on September 23, 2014, 08:46:21 pm

I did one earlier this year at a car dealership, nightmare! Nowt you can do but crack on with it!

Title: Re: re sanding a commercial paved area
Post by: Richard iSparkle on September 23, 2014, 11:39:26 pm

out of interest, why do you say commercial block paving doesn't need resending?  surely the principle is the same with any block paving, that removing the sand weakens the structure of the blocks?

Title: Re: re sanding a commercial paved area
Post by: BDCS on September 23, 2014, 11:44:20 pm

Usually the commercial blocks are 80mm thick rather than 50mm on domestic so you can afford to loose some sand. Dealers prefer not to have it sanded because it blows about and splashes the tyres when it rains - causing scratches etc

Title: Re: re sanding a commercial paved area
Post by: Rob_Mac on September 24, 2014, 12:24:39 am

In the 8 years I have been cleaning store fronts I have only ever re sanded one!

Rob ;D

Title: Re: re sanding a commercial paved area
Post by: Matt Gibson on September 24, 2014, 06:55:49 am

Get yourself a petrol blower. Be quick with the sand. Not too quick, but dont try and get it perfect. Then use the blower to get all the surface sand off into a pile and shovel it up.

I just bought a McCulloch blower petrol blower. £150 from screw fix.

Title: Re: re sanding a commercial paved area
Post by: Roger Oakley on September 24, 2014, 07:07:28 am

I've always re-sanded no matter what the size of area, it forms part of the structure so is needed, it it wasn't then it wouldn't be there in the first place when it was laid. As Matt said get a petrol leaf blower, mine is Ryobi http://www.ryobi-direct.com/ryobi-rbv26-26cc-blower-vac-c2x13951119
Very similar to the one I have. You also get a clearer surface after using, no sand drifts etc.

Title: Re: re sanding a commercial paved area
Post by: Jettaway on September 24, 2014, 04:19:31 pm

I did read/hear from somewhere about sanding with building sand, then topping with KDS. Seems like a  right kafuffle esp with damp sand. Don't know where I picked that up from though.

I keep meaning to get s blower, will get one soon

Title: Re: re sanding a commercial paved area
Post by: Roger Oakley on September 24, 2014, 08:36:27 pm

KDS that's it end of with block paving.