Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: ok cleaning on September 06, 2014, 10:25:46 am

Title: Bat 0
Post by: ok cleaning on September 06, 2014, 10:25:46 am

Bat 0 keeps flashing on my controller the pump is off and have no water coming through guessing the battery's dead , any help thanks

Title: Re: Bat 0
Post by: SB Cleaning on September 06, 2014, 10:33:13 am

Yeah batterys  flat mate

Title: Re: Bat 0
Post by: ok cleaning on September 06, 2014, 12:17:48 pm

Pump works for about 10 seconds then cuts off and the controller reads "bat 0 chg 0 " then starts pumping again the controller reads "bat 99 chg 99" then cuts off again keeps doing it in so confused lol :(

Title: Re: Bat 0
Post by: SeanK on September 06, 2014, 12:23:13 pm

Yes that's a flat battery if you have a split charger you can run the pump for a while with
the engine running to finish off a job.

Title: Re: Bat 0
Post by: ok cleaning on September 06, 2014, 12:26:19 pm

But the battery in the back is connected to the van battery so it should allways be charging ?

Title: Re: Bat 0
Post by: Immaculate windows on September 06, 2014, 12:29:35 pm

Depends on mileage mate, will only charge while engine is running. Pays to top up (bench charge) your battery once a week imo as it keeps battery in tip-top condition.

Title: Re: Bat 0
Post by: SeanK on September 06, 2014, 01:26:19 pm

Quote from: ok cleaning on September 06, 2014, 12:26:19 pm

But the battery in the back is connected to the van battery so it should allways be charging ?

Does the controller work O.K. with the engine running ?

Title: Re: Bat 0
Post by: matthewprice on September 06, 2014, 09:32:52 pm

Found I can get this .found out that it was a loose connection at the battery.