Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: laustin956 on June 19, 2014, 06:08:26 am

Title: Honda gx390 ws202+ whirlaway
Post by: laustin956 on June 19, 2014, 06:08:26 am

Hi just put a new pump on and want to check engine rpm. What should it be set to? Thanks leigh

Title: Re: Honda gx390 ws202
Post by: BDCS on June 19, 2014, 06:49:34 pm

I time 21ltrs into a tub

Title: Re: Honda gx390 ws202
Post by: laustin956 on June 19, 2014, 07:59:17 pm

What nozzle do you use to do that.

Title: Re: Honda gx390 ws202
Post by: BDCS on June 19, 2014, 09:48:55 pm

none - the swept volume of the pistons X the revs = the output. The correct nozzle for a 21 ltrs @ 200 bars is a 065 - watch the RTT for flow with the nozzle in

Title: Re: Honda gx390 ws202
Post by: laustin956 on June 20, 2014, 05:18:14 am

Hi I have 0,15,25,40 and a turbo nozzle all at 065 so to do the test in to a tab I don't have to use a nozzle in

Title: Re: Honda gx390 ws202
Post by: Kenny83 on June 20, 2014, 07:21:38 pm

Also if your sucking out from over the top a drum you will probably need to twin feed the pump
 ;D

Title: Re: Honda gx390 ws202
Post by: laustin956 on June 20, 2014, 07:29:45 pm

Hi i have a twin feed got all the bits from qwashers :)

Title: Re: Honda gx390 ws202
Post by: laustin956 on June 22, 2014, 03:59:28 pm

Hi got myself a whirlaway 16 inch what wound be the best nozzles to put in 030 or 035 got 025 in and the psi was 3500psi

Title: Re: Honda gx390 ws202+ whirlaway
Post by: laustin956 on June 23, 2014, 05:52:01 pm

Any help?

Title: Re: Honda gx390 ws202+ whirlaway
Post by: BDCS on June 23, 2014, 06:31:47 pm

The nozzle for a 202 is 65 so you need two 35's

Title: Re: Honda gx390 ws202+ whirlaway
Post by: laustin956 on June 24, 2014, 07:18:47 pm

Ordered some 030 and 035 to give it a go

Title: Re: Honda gx390 ws202+ whirlaway
Post by: BDCS on June 24, 2014, 07:58:40 pm

30's save water but 35's give better flow - worn 30's are about right

Title: Re: Honda gx390 ws202+ whirlaway
Post by: laustin956 on June 24, 2014, 08:29:37 pm

Thanks for you help just need to sort the unloader out