Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Majestic on February 10, 2014, 05:39:13 pm
-
Having problems with the water flow.
I switch the pump on and it takes about 5 mins for the water to come out of the brush.
I switch it off and the water is still coming out.
Any one else had this
-
You may have air bubble, try taking the hose fitting off the hose that goes into the hose reel, turn on and let the water flow for a minute then put hose connector back on may help !!!! 👳👳👳
-
Cheers will try that now
-
Let me know if it works, hope it does as its so annoying when these systems play up as we rely on them so much 👍
-
Possibility 1. Resin in riser tube (less likely).
2. Sounds daft but did you put something over the riser tube to stop resin getting in - then forget to remove it? :)
3. When replacing a fitting, you used a faulty one or damaged the original.
4.Kink in hose or pole hose?
Remedies.
1. Remove resin from tube and try again.
3. Replace the fittings one at a time. Do it systematically. Keep the originals in case this is not the problem and they are OK.
There are other things to check but they wouldn't relate to a resin change.
-
Don't know if it would cause the problem you describe but have you connected your inlet and outlet hoses the right way around?
-
Let me know if it works, hope it does as its so annoying when these systems play up as we rely on them so much
No luck still the same
-
Possibility 1. Resin in riser tube (less likely).
2. Sounds daft but did you put something over the riser tube to stop resin getting in - then forget to remove it? :)
3. When replacing a fitting, you used a faulty one or damaged the original.
4.Kink in hose or pole hose?
Remedies.
1. Remove resin from tube and try again.
3. Replace the fittings one at a time. Do it systematically. Keep the originals in case this is not the problem and they are OK.
There are other things to check but they wouldn't relate to a resin change.
Yes put cling film over tube and removed it after.
Tried putting water through it before I connected it in the van
Unwound the hose , that's ok
I tried another resin bottle and that's the same