Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Mist A Bit on December 21, 2013, 03:29:45 pm
-
Just got it running had it flushing for ages now producing TDs in is 261 and out is 36 after 1 hour running, how long will it take to come down. My old 300gpd produced at 15 ppm
-
Just got it running had it flushing for ages now producing TDs in is 261 and out is 36 after 1 hour running, how long will it take to come down. My old 300gpd produced at 15 ppm
I'm not sure, Eco, but with a tds of 261 going in you should eventually be producing 2 or 3, l would say. My 4040 converts a tds reading of 360 to 1 or 2.
-
If he has a reading of 261 compared to your 360 and you get results down to 1 or 2, then how do you explain the fact that his Tds will be higher than yours at 2 or 3?
-
My water is going in at 105psi, Easy.
-
Does that go through resin to get it to 1 or 2
-
I haven't used resin in 7 years, JK.
-
Have you got it down now eco-clean??
-
Just got it running had it flushing for ages now producing TDs in is 261 and out is 36 after 1 hour running, how long will it take to come down. My old 300gpd produced at 15 ppm
What's your pressure at the membrane? - this is not the same as the pressure at the mains, when you measure that it is at a 'closed' end, as the water enters the membrane some goes to waste with no resistance, so the entry pressure is lower than the mains pressure. You should instal a pressure guage between the prefilters and the membrane for the most accurate reading.
-
I won't run it again now until after Christmas holidays. Between now and then got to install it in van.