Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Aztec Services on September 11, 2013, 10:29:51 pm

Title: ashby's ninja
Post by: Aztec Services on September 11, 2013, 10:29:51 pm

Hi all

need some advice will be installing 2 x 1500 watt ametex lamb motors no.117123-13 in my ashby's ninja and have purchased 2 foam gaskets from woodbridge commercial however the gaskets are about 60mm thick are they all this thick.



many thanks
paul condon aztec services

Title: Re: ashby's ninja
Post by: john martin on September 11, 2013, 10:42:33 pm

 Chances are it will compress as you tighten the bolts  ...  but better thick than thin , u can always cut it in two .

Title: Re: ashby's ninja
Post by: Aztec Services on September 11, 2013, 11:01:43 pm

sorry i made a mistake the gasket is about 20mm thick not 60mm



paul condon aztec services

Title: Re: ashby's ninja
Post by: John Kelly on September 12, 2013, 07:59:51 am

Should be fine. Don't make the common mistake of over tightening the bolts as this can compress the bottom causing the fan blades to rub creating wear and heat.