Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Simon Mess on September 09, 2013, 04:32:25 pm
-
Does anyone have experience of this?. I have read of this, but so far, have not managed to find some proper info on exactly what is involved, how easy it is to fit, and wiring it up. I know that an immersion heating element is essentially a big version of what you get in an electric kettle, so, in theory, quite simple!. The elements seem to be quite cheap, I have looked on ebay, so if it is do-able, it would make sense. After all, if the water in my 500l tank is warm in the morning when I leave the house, because it is such a large volume of water, it will stay warm for most, if not all of the day.
-
don't do it your self get a plumber to do it will cost you about £150 well worth the money then get some heavy duty cable plug in to mains leave on timer four 5 hours set at 50degrees job done dont do it your self
-
If you are handy with your hands do it yourself. Take a look at this youtube and see if its within your ability.
This was done by a fella on this forum.
http://www.youtube.com/watch?v=XxrgYEurE3A
don`t do it HAHAHA I disagree, do it. ;D ;D ;D ;D ;D
-
Thanks for that link Smithie, doesn't look too hard!!, will see.....
-
iTS NOT AT ALL. tHE ELEMENT INSTRUCTIONS WILL TELL YOU THE SIZE WIRE TO BUY.ALL TO REMEMBER IS USE A POWER PLUG THAT WILL DELIVER THE POWER NEEDED. i USED MY GARAGE FOR QUITE A WHILE. GOODLUCK MATE. If the lead wire is to thin it will get hot so get the right amp size wire.
-
as you can see in the video it is very easy to do I also thought this might help you as well
http://www.youtube.com/watch?v=HbADg657S30
-
I've done it, it really is quite simple but I would advise using a proper mechanical flange- not just cutting a hole, ramming the element in & bodging it up with a tube of sealant!!
The other this is to have a dedicated plug socket from your main fuse board/consumer unit!! A normal house plug socket is not designed to have 3KW run through it for 4/5 hours, I have melted two plugs & had two lucky escapes by this. Now I have a dedicated one from fuse board. ;)
This is what you need-
http://www.toolstation.com/shop/Mechanical+Flange/p38614
-
Thanks for all that info and links everybody, hopefully will get it sussed!
-
Iv fitted one to my tank, it's really not hard just make sure you order the correct
Flange to fit the thread on, is worth it tho. Costs about 3 pounds a night when it's on all night and heats my 400l all the hoses and the van :-)
-
I've done three. One in my present 650L (Long element) One in my present 200L (Short element) and one in my original 400 (short element) which I sold to someone on here about a year ago.
If there is room in the tank without it being too near the sides then the long element is best.