Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Shaun_Ashmore on July 22, 2013, 08:09:03 pm
-
When I start my promount it isnt going to full power when the throttle is on full, infact its labouring, It's got fuel LPG it has oil and the dirty water tank is clean so I dont think its a cut off, any ideas ? these machine are as simple as me so I'm hoping its a simple fix.
Shaun
-
Have you tried removing air filter to see if there is a difference, if not it could be the regulator.
-
Check air filter
Check fuel filter
If the above dont work then it could be back pressure from the HX....to check unbolt the exhaust from the HX and run the machine. If it runs up to speed then have the HX checked for blockages. Also it could be a problem with the govenor on the engine.
-
Richie, it wont be fuel filter, its running on gas :D
-
ahhh yeah my bad LOL
-
Shaun check your wiresto the fuses, one of them may be loose ;D :P
-
Try running on petrol? Show if its an lpg problem.
Remove vac hose from waste tank, it might be blocked? Sucked a towel up?
Change plugs and air filter.
Plug leads?
-
Chris he has sorted it now, he was running it with 100 ft of pipe with the waste gate left open ;D and wondered why he was no getting full extraction :D
-
The real problem was that the water pump switch was knackered it was an intermittent fault.
Shaun