Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: wayne zabel on January 19, 2013, 04:35:28 pm
-
Doing a job today and my Glidemaster hand tool suddenly stopped working properly,basically only jetting from one half of the nozzle now - any ideas about whats gone wrong and ease of repair.Is it just a replacement nozzle and is it an easy job?
Thanks wayne
-
remove jet & blow through it prob just a bit of debri part blocking the jet,,,,,,do not clean jet using a pin..
Lee G
-
took to pieces and done that and its still the same,any other ideas?
Also can I just buy the brass part of the tool without the female quick connect?
Dont want to go to the expense of a whole new tool if I can buy the brass part,
-
can u see daylight through your jet??
Lee G
-
No.
-
its defo blocked then ,,,,try tapping jet on a hard surface thread face down its blocked wiv a bit of debri
Lee G
-
Use a pin wayne definitely blocked mate
-
put the jet into boiling water, leave for a while,then with pliers lift out and put high pressure air through it.
-
After you get it sorted get one of thing me bob filters
-
As above its just blocked, put itin some hot descaler for 10 mins then flush it through with your highest psi. If that does not clear it then it may be a git of glass or grill that it lodged and you will have to persivere with a pin or fuse wire till its clear.
-
Thanks for all the help - all sorted now.
Stood in boiling water,poked with a pin and banged it on the floor,dont know which worked but I do know its jetting properly now :)