Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: dave f on December 04, 2012, 12:29:18 pm
-
i got a fog wash last year only used it a hand full of times then left it redundant any way i thought ift was a waste of brass i thought i would give it a chance i tride to to get it going it just wont have it tride, low flow got the 2 numptys just on. ie gas and the water. cant seem to get it going for more than a minuet ive a aquadapter fitted to pole its doing my tts in any advise wouldbe greatfully recived
-
Fit new batteries first. Then when you do get it to fire mark where the flow k nob is so that you can get it back again. Too much water flow or too little and it will cut out. Also make sure it's well ventilated cos there is a co2 trip switch on it too.
-
brand new bateries noticed that if you leave it with out water running out it cuts out cantget it realy hot with out cutting out i know it aint got to be red hot seems to wor >:(kish when you have a high flow
-
Is it the reset button, that is causing you the problem?
It is located on top of the heater on the right side press it and try again.
Roy
-
been out had a play its very tempramental dose wot it wants if you turn it of say when you go to next job then start it it wont ignite you have to turn up flow rate then your ff just reajust then ur off fannyed about think imay have got the hang of it if you have one wot do you have yours set at im determend not to be beat >:(
-
I have two marks on mine I've put on with sticky tape so I know where the flow range is. You might need to fiddle a bit with your controller to get it just right too. Could be the reset button as mentioned 'cos you'll be closing your van back up between jobs.
Mine runs really well through a flue but it took me a while to sort it.
-
i hav evan side door open ive got the controler at 25 it seems faster water is just about body temp may be a bit more its on winter setting