Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: ascjim on October 16, 2012, 08:33:42 pm

Title: Drilling and cutting holes into van
Post by: ascjim on October 16, 2012, 08:33:42 pm

Will be putting anchor points and making a small hole in the floor of my new van soon, am just wondering if i should use any paint or rust protection product afterwards? This van is new new! so im going to try and look after it like the wife....

Peace x

Title: Re: Drilling and cutting holes into van
Post by: Ian101 on October 17, 2012, 09:07:00 am

if it was a new van and mine I would use a rust inhibitor then primer then paint then possibly protectakote it


however my van is an old un but a good un so prob just spray a bit of hammerite over bare metal  ;D

Title: Re: Drilling and cutting holes into van
Post by: steve m on October 17, 2012, 11:02:25 pm

talk to the dealer, just to mke sure your not invalidating your anti perforation warrantee