Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: WCS Limited on August 15, 2012, 08:59:02 am

Title: di question
Post by: WCS Limited on August 15, 2012, 08:59:02 am

refitting the van this week and i'm in two minds about where to put my DI. until recently i was putting the DI after the pump and before my heater unit and leaving the filtered RO (40/40) water in the tank and finishing it as i needed it.

my question is would it be better to put the DI in sequence after the RO so it fills the tank with pure water but, will my 37psi tap pressure (going into the pre filters) be enough to push it through the 40/40 (HF5) and then through the resin beads ??? ???

Title: Re: di question
Post by: richardlingard on August 15, 2012, 06:41:33 pm

if it aint broke dont fix it bud