Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: SherwoodCleaningSe on April 04, 2012, 09:02:09 pm

Title: Vyair pressure switch.
Post by: SherwoodCleaningSe on April 04, 2012, 09:02:09 pm

I have 2 Vyair pumps both with controllers and the pressure switch on one is too sensitive, it keeps turning the pump off for no reason.  Does anybody know where I can get a replacement pressure switch that fits?

Thanks Simon.

Title: Re: Vyair pressure switch.
Post by: G & M on April 04, 2012, 11:23:14 pm

those pumps are sold on ebay. you should be able to get one there.

Title: Re: Vyair pressure switch.
Post by: richard jagger on April 05, 2012, 05:36:59 am

Can you not adjust its switch?I am sure there is a setting screw under the switch lid or you have so obstruction on the pipeline obstruction not allowing the water flow.

Title: Re: Vyair pressure switch.
Post by: gto on April 05, 2012, 08:40:50 am

if your using a controller, can't you just disconnect the pressure switch the same as on the shurflo

Title: Re: Vyair pressure switch.
Post by: SherwoodCleaningSe on April 05, 2012, 09:09:21 am

Thanks for replies.

You can't adjust this pressure switch, it's not covered up with anything and no screws on it.  I could run the pump without the pressure switch wired in but I'm running it on a liquid logic unit and they don't have soft start up like varistream, so the pump would eventually over pressurise if left dead ended. I will have a look on eBay.

Simon.