Clean It Up

UK Floor Cleaning Forum => Hard Floor Cleaning Forum => Topic started by: mike roberts on November 13, 2011, 11:16:12 am

Title: quarry tiles factory floor toilet
Post by: mike roberts on November 13, 2011, 11:16:12 am
As above ... Nice job eh...

Any advice on best chem we usually qmt stone clean + acid as reqd
Thks Mike
Title: Re: quarry tiles factory floor toilet
Post by: Patricia Johnson on November 14, 2011, 01:45:53 pm
Try using CRYSTAL SODA ( TESCO OR SAINSBURY) pound a packet!!!!!! Acid will cause  tiny pores in the tiles which will hold dirt. Use a cleaning brush, avoid pressure washing and hot water. Diversey's SPEEDSTRIPE is also very good because it contains XYLENE, Use a vac!!!
Title: Re: quarry tiles factory floor toilet
Post by: Kev Martin on November 14, 2011, 04:34:27 pm
As above ... Nice job eh...

Any advice on best chem we usually qmt stone clean + acid as reqd
Thks Mike


Mike

High Alkaline Cleaner such as Aqua Mix Heavy Duty.  Pre wet the floor then apply the High Alkaline Diluted accordingly and allow to dwell, agitate then pull to one side with a squeegee.  If the results are OK vac up solution and rinse then vac again.  If not OK add a little 220  or 320 Grit Aqua Seal Hone Powder and agitate then Vac and rinse.  The results will be perfect mate.

Kev Martin
Marble Life Ltd
Title: Re: quarry tiles factory floor toilet
Post by: Patricia Johnson on November 14, 2011, 11:28:49 pm
Why aqumix when you can buy products from your local stores.
Title: Re: quarry tiles factory floor toilet
Post by: Floor_Tony on November 15, 2011, 12:15:26 am
Read it he said the word 'such as' 'high alkaline cleaner' your 62/63 act your age offer some advice not jibes at Kevin all the time or is that what you are here for....?

Title: Re: quarry tiles factory floor toilet
Post by: Kev Martin on November 15, 2011, 10:09:44 am
Why aqumix when you can buy products from your local stores.

Amir

Professional Cleaning contractors whether they be hard floor, carpet, pressure washing etc would never turn up to a job with DIY products from a local store or they would look like idiots.

Kev Martin
Marble Life Ltd
Title: Re: quarry tiles factory floor toilet
Post by: mike roberts on January 09, 2012, 05:39:16 pm
As above ... Nice job eh...

Any advice on best chem we usually qmt stone clean + acid as reqd
Thks Mike


Mike

High Alkaline Cleaner such as Aqua Mix Heavy Duty.  Pre wet the floor then apply the High Alkaline Diluted accordingly and allow to dwell, agitate then pull to one side with a squeegee.  If the results are OK vac up solution and rinse then vac again.  If not OK add a little 220  or 320 Grit Aqua Seal Hone Powder and agitate then Vac and rinse.  The results will be perfect mate.

Kev Martin
Marble Life Ltd


Hi kev,
Thks for advice used your '320 Grit Aqua Seal Hone Powder' purchased from yourselves Amazon only needed small quant ! (bloody aqua seal  ;D ;D ;D ) thks for  quick del service will feedback on Amazon  ;D

Worked really well, when required, turns out job also included fully tiled shower areas.... man really negleted.. in such a condition had to use acid - results were fantastic  ;D ;D
thks Mike



Title: Re: quarry tiles factory floor toilet
Post by: Kev Martin on January 09, 2012, 08:32:55 pm
Mike

Glad you liked it.  If you need anything else open a trade account mate and save some dosh

Kev Martin