Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: mark bowditch on August 30, 2011, 08:18:55 pm

Title: Pressure washing paving with gravel joints
Post by: mark bowditch on August 30, 2011, 08:18:55 pm

Pressure washing paving with gravel joints is about 20 mm joints with small gravel
Would a flat surface cleaner be ok any advice appreciated
Thanks
Mark

Title: Re: Pressure washing paving with gravel joints
Post by: Alan McTernan on August 30, 2011, 08:52:01 pm

Hi Mark,

Good Luck ;)

The best way i find to deal with these and gravel borders is to have a strip of exterior ply in the van that i stand on at the edge i am cleaning (with a lance), hence not blowing the gravel everywhere!!!

Hope this helps. ;)

Regards
Alan

Title: Re: Pressure washing paving with gravel joints
Post by: mark bowditch on August 30, 2011, 09:13:28 pm

Hi Alan
Thanks for the reply it is random lay with gravel joints instead of pointing don’t fancy sticking a board round that lot might be quicker to vacuum up the gravel in the joints.
Did you get my e-mail in April about your website?
Regards
Mark

Title: Re: Pressure washing paving with gravel joints
Post by: JSMC on August 30, 2011, 10:18:59 pm

i vacuumed gravel up other week when doing a job