Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Jon Tabbener on July 21, 2011, 05:45:10 pm

Title: Any Idea
Post by: Jon Tabbener on July 21, 2011, 05:45:10 pm

i'm sure it's something simple

doing a job today with my porty (prochem)  - the machine vacs kept cutting out as if the waste tank was full it would run for a few minutes & then start screaming

Now there was some foam on the top of the waste water thanks to 1001 but as was only a small job only extracted about a bucket full  - when i checked the waste tank it didn't look like the foam was getting out of hand just a layer on top of the water

i didn't have any defoamer on the van i dont use it all the time & must have left it on a job weeks ago

any ideas

Title: Re: Any Idea
Post by: Colin Day on July 21, 2011, 05:55:12 pm

Did you run the motors dry with the waste tank lid open? This can sort things out sometimes!

Title: Re: Any Idea
Post by: southern counties on July 21, 2011, 06:35:38 pm

Lots of fluff on the filter around the ball float can make it cut out. Was it fluffy?

Dave

Title: Re: Any Idea
Post by: Neil Williams on July 21, 2011, 06:46:58 pm

Was it 'losing' suction or simply cutting out altogether?
I thought along the lines of what Dave just said ie fluff clogging up the filter and chocking the suction from the vacs.

Title: Re: Any Idea
Post by: from edge2edge on July 21, 2011, 06:54:25 pm

Jon remember to stick a bar of soap in the waste tank if no defoam  ......................Alan(swindon)

Title: Re: Any Idea
Post by: Jon Tabbener on July 21, 2011, 07:48:13 pm

Thanks for the replies guys - re the soap Al already got my best bar of imperial leather in there  ;D

i'm just about to give it all a good clean out & leave vac on for about 10 minutes could be fluff never happened before though

it wasn't losing suction at all just the ball float raising up & making the vacs scream like the waste tank is full

Many Thanks

Title: Re: Any Idea
Post by: Jamie Pearson on July 21, 2011, 08:44:14 pm

Is it a steempro. Sometimes on older models the waste intake elbow turns in the tank when you are fitting/removing the hose causing it to spray towards the float valve.

Title: Re: Any Idea
Post by: M.Acorn on July 21, 2011, 09:00:18 pm

My machine had a massive build up,blocking one of the vac motors completely