Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: BEN DAVISON CLEANING on June 18, 2011, 06:21:13 pm

Title: blown fuse
Post by: BEN DAVISON CLEANING on June 18, 2011, 06:21:13 pm

 cleaning a carpet this morning and halfway through the clean the fuse went in the plug powering the two vacs and the pump went.So i changed it checked over my machine.The only thing i could see that might be wrong was that the filter in the waste tank was completely blocked. Unblocked it carried on and ten minutes later it went again.luckily id just finished  :D

Any ideas on what the problem could be.Its never done this before :)

Cheers Ben

Title: Re: blown fuse
Post by: markpowell on June 18, 2011, 06:57:12 pm

either a break in the cable, or a fault in either vac or the pump.
try each switch seperatley and see which trips.
If none it will be the cable
Mark

Title: Re: blown fuse
Post by: BEN DAVISON CLEANING on June 18, 2011, 11:55:45 pm

makes sence mark.The ends of the cable that connect into the machine are prity flimsy.Will check in the morning.Cheers mate :)

Title: Re: blown fuse
Post by: markpowell on June 19, 2011, 08:12:35 am

Run the vacs for 15 mins each seperatley to make sure they are ok.
Mark