Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: jhagger on October 08, 2005, 02:04:39 pm

Title: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:04:39 pm

 ??? i've just been delivered a DIY system from wintecs, after reading some great reviews on this site anyway not sure if im being dumb or not but it didn't come with any instructions? i know theres not that much to do but quite a few connectors and no idea which goes to where, anyway their closed til monday and i'm stuck any help would be much appreciated

cheers

Title: Re: HELP!
Post by: Davindo Cleana on October 08, 2005, 02:08:44 pm

what kind of system - is it a trolley

Title: Re: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:11:30 pm

no it's installed in the van a 175 litre tank with the pump, resin and everything else in the van

Title: Re: HELP!wintecs DIY system?
Post by: Davindo Cleana on October 08, 2005, 02:13:28 pm

do you want a sequence of what goes where in the chain on the van

Title: Re: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:16:41 pm

yeah that would be a great help, was hoping someone may have an instruction sheet as i'm confused with all these connectors but any help will push me in the right direction

Title: Re: HELP!wintecs DIY system?
Post by: Davindo Cleana on October 08, 2005, 02:23:33 pm

When I started I drew a diagram of the chain and it helped with the basics - there's obviously more to it that that but I hope it can help

Outside tap - ro - water butt - submersible pump and hose - van mount tank - pump inlet - pump oulet - di - hose reel - pole

plenty of thread tape on connectors - use decent ones -
fit the pump with the hose connectors at the bottom or lain flat - if they are on the top and you get a leak they could foul the electrics

use stop connectors wherever you are likely to have to break the hose - to pole etc

you might not need to pump your water if it's a smaller tank - you could just fill smaller cans and fill the tank manually

Title: Re: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:29:25 pm

yep makes look simpler when you break it down!although this system works by filling the in van tank with tap water-then in purifies it before it sends it through the pump and up the pole.is it stil the same process you described? cheers for the help!

Title: Re: HELP!wintecs DIY system?
Post by: Davindo Cleana on October 08, 2005, 02:31:21 pm

Sounds like it - are you just using di or is there an ro on the van

Title: Re: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:35:00 pm

di i think? theres only the resin cylinder to purify the water

Title: Re: HELP!wintecs DIY system?
Post by: Davindo Cleana on October 08, 2005, 02:38:13 pm

Spiffing - then just follow the chain form the van tank part - you probably will get a couple of leaks till you suss it out but that's all part of the fun

Good luck

Title: Re: HELP!wintecs DIY system?
Post by: jhagger on October 08, 2005, 02:46:30 pm

nice one for that mate though i was stuck til monday!(ehen their open!)