Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Pole 2 Pole on May 27, 2011, 04:11:02 pm
-
I ain't got a complex setup. Just a upright 250l connected to pump and varistream......connected to hosereel. But whenever my water level drops to I guess where the submersible is.......I keep getting locks. What's the best way to clear it please you lovely people x x x
-
Is your pump as low as it can be?
-
Simplest way I've found is disconnect your hose reel, turn on pump, and suck until you get a mouthful of water.......... no airlock!
-
Run the pump flat out for a few seconds that should clear it.
The pump should be as low to the floor as possible & it's feed pipe should have no high points in it.
-
Sorry panorama. Had to do the Tesco run. No pump is kinda halfway up as far as height goes. Should it be lower???
-
Ignore me. Just seen that. So what exactly causes it???? Please don't anyone say "air" ;D
-
Gravity.
-
Just tried sucking air out. Sorted. I cant really have pump any lower as there's nowhere on van to secure it. Thankyou boys.
-
The hose does kinda travel in am "n" shape. Not good I guess....
-
The pump does not have to be too secure. My pump is on the van floor cable tied to the floor straps.