Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: www.mrgutters.co.uk on May 10, 2011, 06:49:57 pm
-
hi all i have a 4040 ro thats been running fine off a 100 psi shurflo ass its booster for ages say 3 years but it packed up and i deicded to buy a mains booster pump as alot of people use these its the tanked version
but cant seem to get it to work for more than a couple minute so no pure water coming out
any help much appreciaated
currently its running
had it running
mains booster --------prefilters------ro----di------nothing coming out
but alot of pressure on the waste in both cases
http://cgi.ebay.co.uk/Water-Booster-Pump-1200-Watt-60lpm-8m-delivery-height-/170629164041?pt=UK_HomeGarden_Garden_PondsWaterFeatures_UK&hash=item27ba4a6c09#ht_888wt_648
tap ----------prefilters --------booster pump-------ro-----di ---nothing out
-
dont think you should have the prefilters after the pump...it could damage the filters! also have a look at your solenoid switch!
-
where would the solenoid swith be ... it build up pressure but then tank fills up thats its no water comes out the ro
pressure is reading at 45 psi
tap pressure 23-25psi
shawn
-
On the brass connector at the top of the pump, where the pressure gauge is there is a small black box. It will have wires going into it. You need to remove a screw or nut and remove the cover of the black box. Make sure the pump is not live or plugged in. You will see two adjustable nuts in there which have springs behind them. Screw the larger of the nuts all the way in as far as it will go and slacken the smaller one right off.
Order of things should go Tap> pump>pre filters> RO>
-
thanks very much for your hlp mate
will try it out in the morning
shawn