Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: neiljoust on May 08, 2011, 06:30:18 pm
-
where can i get a diagram to where the pipes go on my Compact Reverse Osmosis Systems 200
-
when i take of the flush pipe it comes out really fast think its stuck on flush it still comes out of the flush pipe when turned off any ideas please are the pipes on wrong
-
Neil,
You sound like you're having a bit of a nightmare. If I was local, I'd pop over, but I'm not. Do you know any local window cleaners that could help?
-
If you don't have a booster pump connected it probably sounds right.
How long does it take to produce a litre of pure water?
-
about 3 hours
-
just found out even if the flow valve is switched off it still comes trew that pipe not as fast when open help going to have a break down lol
-
neil go here
http://www.ro-man.com/instructions/RO-MAN%20Reverse%20Osmosis%20manual%20for%20200%20and%20300%20GPD%20systems.pdf
-
i close the flush pipe and then the water comes out of red pipe(waste) then water trickles out of blue pipe( pure)takes about 2 half hours for 25 L barrel
.2
-
hi thank you but only got white pipes no green got 4 white pipes and a blue one, also hae a t junction looking at the picture you gave me where does the single flush pipe go or is it me being thick on the membrane filters there are 1 connection at the end and two the other end one is white and one is clear one is really pressured(the clear 1 when full of water the white one just drips out when i put the flow valve on the white one the water fills the tank really quick but higher tds reading if i swap it it drips out but the tds comes right down thanks neil