Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: thewindowcleaner1 on September 29, 2005, 07:23:19 pm
-
I run Merlin at present but I know I,ve read on this forum that there is a better one for fitting in vehicle to produce water on site at a good rate,
I've been going though past thread's until my eyes have changed sides.
any help welcomed
Alan
-
Hi Alan,i also run the merlin as you know,iv`e read that the trouble with the merlin is that it doesn`t bring down the tds readings aswell as other ro`s,unless you add a booster pump,but this reduces the life span of the membranes,but it does produce about 3000 litres aday as standard,im quite happy with the way mine runs,but i would like to know myself what other ro`s are reccomended,Gaz.
-
ive just purchased a booster for my merlin from chic cleaning cedric is a good man i am in a hard water area tds from tap water is 581 after ro 21 now with booster 7
well worth yhe money and chic is the cheapest
-
ive just purchased a booster for my merlin from chic cleaning cedric is a good man i am in a hard water area tds from tap water is 581 after ro 21 now with booster 7
well worth yhe money and chic is the cheapest
How much did you pay altogether with vat &delivery,cheers,Gaz
-
I have a pentair 4 x 40 R/O and it will fill 1,000ltrs in 3 hours, thats faster than 2 of us can use it.
My tap tds is 234 and it comes out the R/O at 0.01 with a waste ratio of 1 to 1.
Roy
-
Hi Roy
Thats great going can I ask were did you get it from and mose of all how much?
Steve
-
i sell it all on a stainless steel panel with booster pump, needle valve, cut of solenoid and float switch for telling system to stop making water ,it comes with all connectors for whatever use you intend to use it for .van panel comes with either battery to use as a van mount with a split charger abilitity to mean never need to charge its battery or mains adaptor for use as a static it has a ratio rate of only 25 % being rejected so it is adaptable and effeciant in making water , its currently our biggest seller , 01435 873555 or 07944227635 tony
with booster will make approx 3.5 liters a minute from most main presure bringing the tds down to anywhere from 001-012 worst case depends how high your water tds is
i know its not where you bought yours from roy but its the same 40x 40 membraine
cost £1000.00 plus vat
-
Hi Steve
I bought mine from stream, costs about £500 for R/o and then 20" Fillter housings and 25" D/I colum your not going to get a lot of change out of £1,000.
So Sair offer with cut off ect seems a good one.
Its top bit of kit and I like the fact if I put it on in the morning for a couple of hours you have more than enough for one man.
Roy
-
I have a pentair 4 x 40 R/O and it will fill 1,000ltrs in 3 hours, thats faster than 2 of us can use it.
That's the one I was intrested in thanks Roy
Forgot that I posted this (September)
As They say all good things come to those that wait..
-
yeah that system for 1000+ sounds good i need to save for it though !i have spent enough as it is !
can you buy just the 40 inch ro ?? and where from
shawn
-
This is the cheapest place for a 40 x 40 RO.http://www.gapswater.co.uk/acatalog/Reverse_osmosis_kits.html
Nel.
-
ours is cheaper if bought individuly 01435 873555
-
cheaper than £600
-
yes
-
Sair
Can you tell me how your sytem automaticlly shuts off when the tank is full.
Also can I purchase this from you and how much?
Thanks Roy
-
i use an auto shut off valve ,when the water reaches the valve it lifts it and turns the water off they cost about £15
gary
-
Hi Gary
Is it a ballvavle that you use?
As mine is on the van and the movment of water play havoc with the plastic ball vavles.
Roy
-
so they you wanted to get a 4 x 40 ro , what all do you need with it and how much water can it produce ?
shawn
-
Shawn
My 4 x 40 produces 1,000 in 3hrs.
I have 2 x 20" fillter housings that contain 1 carbon fillter and on sediment fillter.
also 25" x 8" d/i colum.
It does same job as a small unit except faster and a bit more efectivly.
Roy
-
so mate
if i was to build up my own system , what order would that go in .... di ro carbon etc
shawn ???
-
First 20" fillter housing with sediement fillter.
Second 20" " " " Carbon Fillter.
Then 4 x 40 Ro
Then I have water in to tank at 0.01 tds.
Then from tank through pump through 8" x 25" d/i colum down hose on to window.
Roy
-
have you got pic of your setup ?
thanks mate
-
roy is yours boostered to make 1000l in 3 hours i would imagine it is as 5.5 l a min is unusal for mains pressure , exceptanional.
and i do sell cut of seperate , it consists of float switch and solenoid and eco flow regulator it has to be set up correctly before r/o to cut of the r/o so depends if r/o are on board or not 01435 873555 0744 227635
-
Sair
no its not boosted and water preasure is just over 85psi.
My r/o is on the van and have a varistream allready.
I will give you a ring
Roy
-
Shawn here is pic of set up.
Roy
-
looks good matie , i might just copy that
thanks shawn
-
do you find the di vessels and hoselock fittings all leak i always have water dripping out of my van !
shawn