Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: david holland on March 20, 2011, 07:39:15 pm

Title: pressure washer prroblem
Post by: david holland on March 20, 2011, 07:39:15 pm

hi  i neednsome advice

Title: Re: pressure washer prroblem
Post by: jaespray on March 20, 2011, 07:47:18 pm

hi david   here is some advice     give us detail   and lots of it
regards john

Title: Re: pressure washer prroblem
Post by: david holland on March 20, 2011, 07:52:58 pm

that was quick  :)

Title: Re: pressure washer prroblem
Post by: jaespray on March 20, 2011, 08:02:06 pm

hi david   lets keep on one thead


are you pulling water from a "bowser"   or striaght from a tap
regards john

Title: Re: pressure washer prroblem
Post by: david holland on March 20, 2011, 08:09:16 pm

jon thanks for replying - pulling from a bowser and i even tried to lift it higher ie above the pressure cleaner to get a better flow rate - still did exactly the same

David

Title: Re: pressure washer prroblem
Post by: jaespray on March 20, 2011, 08:16:08 pm

hi david  tried to check your model on the internet     could not find the flow rate   do you know   
how many ltrs does your bowser hold
regards john

Title: Re: pressure washer prroblem
Post by: Blast Away on March 20, 2011, 08:31:14 pm

One of mine did the same last week. Changed the seals in the pump.

Title: Re: pressure washer prroblem
Post by: Matt Gibson on March 20, 2011, 10:01:39 pm

Is it easy to change the seal in a pump? im assuming it would save a fair wedge if you did it yourself

Matt

Title: Re: pressure washer prroblem
Post by: david holland on March 22, 2011, 09:01:46 pm

sorry about delay in responding (internet problems) - thanks for advice- will attempt the seals - if that doesnt sort it ,any further tips much appreciated


thanks to all

David

Title: Re: pressure washer prroblem
Post by: david holland on March 24, 2011, 07:10:07 pm

all sorted now - thanks for input and and a big thanks to john at jaespray for the advice- after everything it was a knackered old feed pipe from the bowser- replaced that with a wider commercial pipe and hey presto !!!


thanks again

david