Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: davep on January 24, 2011, 03:08:25 pm

Title: Changing envirodri brushes
Post by: davep on January 24, 2011, 03:08:25 pm

Does any kind soul know how to change brushes?

Title: Re: Changing envirodri brushes
Post by: mark shannon on January 24, 2011, 03:17:42 pm

Dace you just push the iron spindles on your picks through. If stiff use hammer gently .

Grease em to make it easier in future.

Title: Re: Changing envirodri brushes
Post by: davep on January 24, 2011, 03:20:57 pm

Mark do you mean the 4 holes?  ???

Title: Re: Changing envirodri brushes
Post by: mark shannon on January 24, 2011, 03:22:37 pm

No 2 silver ones in middle

Title: Re: Changing envirodri brushes
Post by: davep on January 24, 2011, 03:25:09 pm

Ah I see, thanks, tried earlier but stuck.  Will get the hammer out  ;)

Title: Re: Changing envirodri brushes
Post by: Joe H on January 24, 2011, 04:24:59 pm

Dave
They only come out one way

Title: Re: Changing envirodri brushes
Post by: Kinver_Clean on January 24, 2011, 04:50:59 pm

One end is round the other six sided. GENTLY tap the six sided end and the bar should pull out. Make sure the ends of the brush and hopusing are clean as grot can get in the hole and jam up.

Title: Re: Changing envirodri brushes
Post by: richy27 on January 24, 2011, 05:02:52 pm

when you do get them out  grease the shaft well too make it slide in and out easier in the future 8)

Title: Re: Changing envirodri brushes
Post by: davep on January 24, 2011, 05:20:20 pm

All done thanks. Just persuaded them with the hammer.