Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: LWC on January 13, 2011, 03:44:25 pm

Title: Video of tap on brush head
Post by: LWC on January 13, 2011, 03:44:25 pm

Did a little vid today for you peeps to see how simple this is.

http://www.youtube.com/watch?v=yFIzZyGBfJU

Had one hand filming so couldnt get to tap to get as quick as i usually would.

Title: Re: Video of tap on brush head
Post by: darren clarke on January 13, 2011, 03:47:16 pm

cheers was wondering how to fit ti

Title: Re: Video of tap on brush head
Post by: BORBRYCE on January 13, 2011, 03:51:14 pm

Good at ground level. Useless when the pole is up, which is a helluva lot. That would do my nut in. Far easier with an A-D.

Title: Re: Video of tap on brush head
Post by: LWC on January 13, 2011, 03:54:27 pm

Why though? Do you really go to hassle of turning on and off between EVERY window? By the time youve pulled it you coulda just gone on to next window.

I do all tops first bring it down, do downs and then turn off to go round back and so on.

Besides i still have my rectus 21 coupling if its up and i wanna switch off which not far from the pole end when its up.

Title: Re: Video of tap on brush head
Post by: BORBRYCE on January 13, 2011, 03:58:09 pm

The time to pull takes a blink of an eyelid if that. I turn off for every single window and sometime between top hoppers and lower panes. Also when walking around or when looking around or when talking to someone. It is good mate but again useless at height, it just wont save any water at all.

Title: Re: Video of tap on brush head
Post by: LWC on January 13, 2011, 04:01:45 pm

Wasnt having a dig lol...to me pulling that on and off would personally do my nut in, no way would i do it between every window. I suppose i do flick it on and off alot on lowers and when custies come or untangling the hose from the wheelie bins etc lol etc.

Does save a bit of water. Its just the convience for me  ;)

Title: Re: Video of tap on brush head
Post by: Smudger on January 13, 2011, 04:56:10 pm

Sensai,  nice job mate, but in the long run the AD is far better due to being able to turn off
at height, it's not just turning off between windows altho, by the end of the day it all adds up but being able
wipe upper sills without the water still running and to intantly turn water on only when needed - i use fans and
high flow so if i have to extend up and over a conny or extension water is wasted while getting into position.

if the AD did not exist - then thats where i would have a tap.

Darran

Title: Re: Video of tap on brush head
Post by: barry mallett on January 13, 2011, 05:10:32 pm

Quote from: Sensai LWC on January 13, 2011, 03:44:25 pm

Did a little vid today for you peeps to see how simple this is.

http://www.youtube.com/watch?v=yFIzZyGBfJU

Had one hand filming so couldnt get to tap to get as quick as i usually would.

theres griff trying his hardest to be funny . and you just do it so naturally . april 1st defo come early ;D

Title: Re: Video of tap on brush head
Post by: barry mallett on January 13, 2011, 05:12:26 pm

in fact why not have done with it and put your tap on your hose reel in the van ;D