Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Poles R Us on December 11, 2010, 02:44:14 pm

Title: immersion
Post by: Poles R Us on December 11, 2010, 02:44:14 pm

fitted it its now working  ;D  6" from base of upright tank set at 50

Title: Re: immersion
Post by: Lee GLS on December 11, 2010, 07:25:19 pm

how did  you do the nut up with it being in an upright?

Title: Re: immersion
Post by: Poles R Us on December 11, 2010, 07:47:12 pm

mine is 500 upright , i streched my arm in and screwed the inner part through the hole , then got a ajustable on the outer nut tightend it up so the inner part pulled right up to the inside wall .
 then i loosend  the outside nut off and put a little sealant round the edge of the hole and , pushed the washer on, then the nut and tightend it all up .
the hole i drilled was tight so i had to sand round the edge to make it slightly bigger.
then i put the washer on the immersion and screwed it in tightened it up and thats it.
DO NOT OVER TIGHTEN THE IMMERSION OR THE FLANGE.
i used ( NAIL & SEAL) sealant its the best , boat builders use it to put inlet pipes for engines in the hulls.

Title: Re: immersion
Post by: wezzy32 on December 11, 2010, 10:11:53 pm

u got pics m8

Title: Re: immersion
Post by: Poles R Us on December 12, 2010, 07:14:16 am

i will try and get some on today

Title: Re: immersion
Post by: wezzy32 on December 12, 2010, 04:13:10 pm

u took the pics yet

Title: Re: immersion
Post by: Poles R Us on December 12, 2010, 04:55:18 pm

not yet , im waiting for my son to do it he knows how to put them on here.