Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: kinder clean on December 09, 2010, 08:57:08 pm
-
Hi all
Got a problem with my powerflite today ( probably caused by the frost )
Its sprung a leak from the left side copper coil ( that wrap rond the vac motors ) Can I simply bypass these coils altogether ? Got a busy few days and really don't want to cancel the weekend work, was going to call at Pirtec tomoz as the connections I want to join are both male.
Did take a photo of this ( while lying in the snow earlier ) but cant get the bloody thing off my phone ! ;D GOT IT NOW
Hope everyones doing ok, not been on for a while.
Take care
Paul
-
Why not? it's only a glorified heat exchanger.
Shaun
-
paul gve us a buzz on 07595727491 think i know how to do i will talk you through
ps i will be going zzzz at half ten
-
Those hoses are only held on with Jubilee clips. Simple job to take off the fittings, find a peice of tubing same diameter as inside of hose, fit hoses to tube and re-tighten Jubilee's.
-
if i am not mistaken by the side of the pump there is a small lever normaly zip tied down ( in the factory ) this lever stops sol going through the heat system in creatin a by pass bieve its on the left hand side of the pump in the iner compartment of the machine
-
Yes it can be done.
Call Dave at Amtech he will tell you how.