Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Klean07 on December 08, 2010, 03:23:40 pm
-
Found out this morning that filter housings had all cracked. So was looking in my other shed and there was an almost complete new merlin that was minus the pre-filter and housing. So Ive spent the entire afternoon putting this new one together. All pushfits and pressure gauge no probs. The thing thats driving me crazy is putting the filters and housing together. (yes sounds easy) and it should be. But problem is the housings get to about half an inch from from the casing and wont tighten no more.
Any ideas appreciated.
-
do they screw in all the way without the o rings on ?
-
yes they do screw up without o rings on funny enough.
-
Just checked mine and they are screwed up tight.
-
i had same prob, just push o rings all the way over thread you
will see them when you do housing up but works fine .
-
Hiya juice, but wont it leak if not fully tightened?
-
It's prob the friction from the rubber seals.
Put a tiny amount of fairy liquid on the seal and it should glide on.
Have had this problem myself, this fixed it and did no damage to filters / membranes
-
Also make sure you've got the filters / membranes right in the centre.
-
Cheers its sorted now. I did that lubrication thing. But found it a lot easier to tighten up using the spanner from the housing.
All we need now is some good temps.
-
was going to say use the side housing
whats a spanner ;D ;D
-
Will try a bit of fairy on mine then i just thought they had sent the wrong sized rings
thanks form B
-
was going to say use the side housing
whats a spanner ;D ;D
Soz I didn't realise housing leg doubled up as a spanner. Wouldn't have known that if thing hadn't froze up.
9 days now without earning a penny!!! ???