Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: DaveG on December 01, 2010, 04:56:49 pm
-
Hi guys
Ive just installed an L5, but it will only fire up with the gas regulator and water flow turned right down??
Also the "water out" hose looks like its been sucked thin???
Ive connected it from tank to L5, then L5 to pump and so on...
Any ideas?
Cheers Dave
-
no you put it after pump and yes flow on minimum
-
Would/could the heat damage the pump?
-
i beleve so
Would/could the heat damage the pump?
-
cheers tomy :)
ill change the pipework over tomorrow
-
I would get a plumber to have a look ;)
-
no nead for plumer ,just hose lock on in and out let ,that way just unclip and remove the bras scrwe 20 secs job dun for frosty nites cos ther not ment for ice
-
I would get a plumber to have a look ;)
cheers ;D
-
Ok Ive changed the pipework like tomy recommended and have solved that little problem....
But now the L5 fires up for about 10 seconds and turns off (it will fire up again if i re-set it but cuts out after 10 seconds again)
Cheers in advance guys
Dave
-
Yeh have to pump through the heater yeh, not pump after the heater, pump before to trigger it.
-
Yes mate tank---pump---L5---DI---reel
-
Sorry, didnt realise someone just said that, just saw your post about having pump after L5
10 second timeout? Is that with pump on a good rate? I used to have my digi varitstream on at least 4 for it to work.
-
you nead the flow on L5 rite down thets on the frunt of L5 then you nead good flow on pump
-
I'm having a similar problem... the heater stays on for a bit, then cuts out, and has to be restarted from the ignition. Just a question, does the brass bleed screw underneath need to be all the way in??
-
I think it will need to be screwed right in or it would leak
-
Do you guys that use gas heaters have a sticker on the back of the van? If so what one..compressed gas/lpg?
Cheers
Dave
-
H20se acs forum m8
under hot L5 as its own section
r jus ask nat jones ;D ;D
-
Ok Ive changed the pipework like tomy recommended and have solved that little problem....
But now the L5 fires up for about 10 seconds and turns off (it will fire up again if i re-set it but cuts out after 10 seconds again)
Cheers in advance guys
Dave
This happens if the heater thinks the flame has failed.
If you take off the cover you will see 3 metal pins going into the flame,.. 2 of them spark & the third is the flameout sensor. Make sure the sensor is in the flame above a burner where it will get properly hot,.. about 10mm above the gas outlet normally.
-
Do you guys that use gas heaters have a sticker on the back of the van? If so what one..compressed gas/lpg?
Cheers
Dave
Mine says, 'Zyklon B'.
Thanks SS youre a star ::) ::)
-
I think in the UK you should display this sticker,.. the listing is for an A4 one,.. normally they're much smaller:
http://cgi.ebay.co.uk/Warning-LPG-Highly-Flammable-A4-Vinyl-Sticker-Sign-/120645134898?pt=LH_DefaultDomain_3&hash=item1c1702aa32
-
Do you guys that use gas heaters have a sticker on the back of the van? If so what one..compressed gas/lpg?
Cheers
Dave
Mine says, 'Zyklon B'.
They don't call me, WFP Oberleutnant Max-Hellmuth Nasty-Piece-of-Work for nothing, you know!
Thanks SS youre a star ::) ::)
-
U do not need to put one on van apparently u only need sticker up if u have 300 plus litres on