Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: bobplum on October 18, 2010, 04:27:20 pm
-
can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob
-
u should be fine with that, or u can put a di vessel after ro to get it down to 000
-
Who did you buy the RO from?
-
i bought second hand on flea bay,replaced all the filters and it does have a di vessel after the ro machine
may get a second di
many thanks
bob
-
try using a di vessel in van
-
i say before you do any more spending take all apart and try re-seating all the filters again.
check all rubber seals are ok and not kink,
did you flush????????????
-
i have flushed for about 30 mins it went from 115 to 10 and as stayed at that level if i can use the water at that level i will for now and purchase a second di in the coming weeks and install in the van
my concern was "can i use the water at that ppm"
bob
-
what ro is it???????????????
-
Bob 10 should be ok but it would be nice if you can get 0.
As Franky says, unscrew all fliters and check they are all ok.
Take a reading of the water after RO only, if its coming out at 10 then the trouble is with the di vessel.
I had this prob a couple weeks back, it kept coming out at 13 after DI, stupid me screwed the cylinder the wrong way round ie it was upside down
-
what ro is it???????????????
PURE FREEDOM 100 GPD
BOB
-
can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob
The resin should get it down to 000ppm if not get a bigger resin vessel.
Test the ppm after RO but before resin.
-
can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob
The resin should get it down to 000ppm if not get a bigger resin vessel.
Test the ppm after RO but before resin.
came out as 20 from the ro down to 7 from the di
bob
-
I bought a P F system, always at 000 after I change resin and when it was new.
-
Needs new resin.... 007 is ok to use. Just changed mine over and it was at 011.
Order some new resin in the morning. Twin di vessels will save you £££.
Since using twin di, my resin change has gone from 2 weeks to 3 & 1/2
-
thanks everyone
second di it will be
bob
-
bob mate what vessels do you have installed and check tap reading sometime they fluctuate in winter i have a 25 ltr vessell hooked up to a 16 ltr and a carbon filter tis lasts 4 mths on constant usage just replaces resin in both changed to tulsion resin never tried this before