Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: aallshine on September 28, 2010, 06:54:09 pm

Title: 001ppm
Post by: aallshine on September 28, 2010, 06:54:09 pm

anyone can tel lme please,how further I can go with ppm?at the moment I have got 001ppm,is it still safe to do windows?

Title: Re: 001ppm
Post by: windiewasher on September 28, 2010, 06:57:59 pm

i go upto 7 and have no problems!

Title: Re: 001ppm
Post by: David Kent @ KentKleen on September 28, 2010, 07:00:17 pm

i always stick with 000 BUT i did some tests at home anything up to 014 to 017 leaves them real nice still. hope this helps  ;)

Title: Re: 001ppm
Post by: DanC on September 28, 2010, 08:41:08 pm

002 for me, although you may get away with it a bit higher during winter. ;D

Title: Re: 001ppm
Post by: GB Window Cleaning on September 28, 2010, 08:46:06 pm

i used to use 012, but had a couple of complaints so now its .000 only!

Title: !
Post by: scud on September 28, 2010, 08:50:31 pm

  I have accidently used 30ppm before now and not had a complaint, I happily use upto about 20ppm, but the again I am good!

Title: 001ppm
Post by: DanC on September 28, 2010, 08:53:41 pm

Yeah I did that, went up to about 013 without realising but didn't get any complaints. ;D

Title: Re: 001ppm
Post by: Mike_G on September 28, 2010, 09:05:59 pm

Used much higher than 001 it will be fine

Title: Re: 001ppm
Post by: roundbuilder on September 29, 2010, 12:10:06 am

i have had 51 with no complaints. There cant be much difference at all with 1 or 20 pparts per million its so minute. Id love to know the recomended ppm to change where windows will spot. Im convinced these suppliers are full of it regarding resin  change.

Title: Re: 001ppm
Post by: dazmond on September 29, 2010, 12:18:18 am

well i have 35tds coming straight out of tap sometimes here.so in essence i could just use it with no treatment whatsoever then?? ??? ???

Title: Re: 001ppm
Post by: roundbuilder on September 29, 2010, 12:24:36 am

id try if i were u daz. I have never  tried with mine as 380odd ppm out the tap. Maybe i will though after ro and no resin. Prob a long shot but worth a go.

Title: Re: 001ppm
Post by: Londoner on September 29, 2010, 07:25:13 am

I change my resin around 5ish but I am not bothered by it as long as it stays below 10

Title: Re: 001ppm
Post by: chopsie on September 29, 2010, 06:37:12 pm

Quote from: aallshine on September 28, 2010, 06:54:09 pm

anyone can tel lme please,how further I can go with ppm?at the moment I have got 001ppm,is it still safe to do windows?

i use mine at 3-4ppm as it comes out my ro at that. You tds meter could be 1 or 2 out so using 1 is fine IMO