Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: andy east sussex on September 16, 2010, 02:55:48 pm
-
just got my hf5 4040 membrane from 265ppm reading its taken it to 17ppm well gd just gota order mixedbed resin and i can start :D:D:D:D:D:D:D:D:D:D:D:D what resin do you reccomend i go for ????
-
i have found this the best tulsion mb-115 can get it from here http://www.daqua.co.uk/resins.htm very quick delivery too cant comment on price you may find it a couple of £ cheaper somewhere else but you do get a great service from them.
paul
-
cheers mate shame i havent even got a little to get me going
-
u should be able to clean with 17
-
just checked water coming out its 19 - 20 :(:(:(:(
-
that shoudl be ok dave morris cleans with 15
-
im not sure if i feel confident enough to work with this quality
-
any resin should do you as ur tds is low so you wont use a lot
-
u should be able to clean with 17
:o
Not very well though!!!
-
what you mean andy ???
-
the is a way of thinking that water must be 000 for it to work properly, yet lots use it about that
-
I try and keep mine at 000... But I wouldn't clean with anything over 002... I cleaned with 005 once and it caused problems on certain windows.
Andy
-
I try and keep mine at 000... But I wouldn't clean with anything over 002... I cleaned with 005 once and it caused problems on certain windows.
Andy
005 is the highest I've ever been with it too. It was no problem. Wouldn't want to chance going higher with it - just in case. I do try to keep it to 000 but have occasionally gone higher with it if I haven't had time to change the resin.
-
DID A WHOLE MORNINGS WORK ON 20 PPM ONCE BY MISTAKE, WENT BACK AND CHECKED EVERY JOB AND THEY WERE FINE. BUT OBVIOUSLY 0 IS BEST.
-
that shoudl be ok dave morris cleans with his old underpants on a stick ...
FTFY ;D
-
lol