Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: WES on July 19, 2010, 11:10:41 am
-
My new Flowmaster Digital Pump Controller is saying PS (pressure switch has activated) it tells you to reduce pressure to allow pump to restart.
Have done this about 20 times, still no luck!!
HELP PLEASE........
-
knock the numbers down to about 40 and see what happens, is it doing it when u trun the water off or when it is running
-
it does it when the water is running and stopped. can't get it to do anything else. going to send it back i think.
-
send it back, i got a digi one from gardiners and only says PS when pump is on and water flow is stopped
-
wes mine does it all the time!when i turn it off on my pole tap it alternates between the pressure ive set it at(60) and PS but then starts again when i turn the tap back on.this is normal i think.
are you saying the pump will not start up again when you turn it off at the tap when pump still running?
try setting the calibration higher.that should sort it! ;) ;D ;D
if the pump is just constantly flashing PS and not working at all check the connections and wiring!!
hope this helps
dazmond
-
wes do you mean its just flashing PS all the time whether pump is on or off and whether water turned on or off??
again check the wiring after turning it off and set the calibration higher when you turn it back on again and try that.
hope this helps
if not you can always phone pure freedom! ;) ;D ;D
dazmond
-
Thanks guys, have tried everything suggested but still no luck. its going back to pure freedom tommorrow. so much time wasted on it!!!!
-
It sounds like you have not set it up. Give PF a call I'm sure they will talk you through it and have it running in seconds.
Mart
-
Sent it back, turns out its faulty. Really glad about that as it means i'm not stupid!!!!