Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: Aquakleen Restoration Services on June 28, 2010, 05:35:55 pm

Title: Oil leak on Sigma Pressure washer
Post by: Aquakleen Restoration Services on June 28, 2010, 05:35:55 pm

Hi all,

I have a Honda Sigma pressure washer. The last job I did last week i noticed that every time I stopped and started it there was a small oil mark on the pavement.

Does anyone know what this can be? The unit has approx 25 hours of use only from new.

Many thanks

John.

Title: Re: Oil leak on Sigma Pressure washer
Post by: C-N-C on June 28, 2010, 09:23:23 pm

Hiya skywalker71 mate.....i mean john ;D
I have a pressure washer & under the engine,between engine & trolley,is a rubber gasket.....after a while the nuts come loose on mine & i have to slightly tighten them as i start to seep oil from joints::)
Dont know if yours the same mate,but if it is,check it out dude......
I find with pressure washers,all that rattleling,full pelt loosens nuts here & there....dry it off & c where it's coming from fella ;)
Good luck mate
Kind regards
Justin ;)

Title: Re: Oil leak on Sigma Pressure washer
Post by: Alan McTernan on June 29, 2010, 03:43:56 pm

Mine has leaked from the oil seal between the engine and the pump, just run your finger under the bottom of the housing where it joins the engine. It takes about 10 mins to replace ;)

Hope this helps
Alan